Adjustable circular formwork
Description
The circular formwork RINGFORM by Variant is a practical system for forming of smooth and curved walls. Only 6 types of elements are used: 3 sizes in height 1.2/2.4/3.0 m and 2 widths, 2.4 m for inner part of the wall and 2.5 m for outer. The required radius is easily achieved by using adjustable spindles.
Load-bearing capacity
- 50 kN/m2 permitted pressure of fresh concrete
- High quality film faced plywood with thickness of 21 mm. Film weight 240 g/m2
Easy to use
- Having only 6 standard panel provides much easier planning and forming.
- All the connectors and accessories are easily fixed into the slots and quickly tighten, consequently forming time is efficient and maximized.
- No need for extra holes in plywood. The same anchor hole’s used throughout a project.
- Can be easily connected to the framed formwork Varimax.
- Radii can be continuously adjusted from a radius of 3.5 m upward, simply by turning spindles.
Cost-effective:
- The system elements are pre-assembled and are ready for use simply by setting the desired radius with the adjusting spindles.
- Installation of pre-assembled units minimizes use of crane.
- Smaller quantities are needed, as it adapts effortlessly to any layout.
- High durability resulting in lower the expense.
- Low cleaning cost and restoration.
- High quality of concrete surface minimize finishing work.
Safe use:
- Accessories such as — bracing platforms, bracing struts etc... make for save and easier handling of the system.
Fast working:
- Radii are set easily—simply by turning spindles.
- Can easily be combined with Varimax, Varimid, Vertex 60.
- There is only one type connection device (Adjustable clamp).
